In a previous blog, I already mentioned a new feature on the AS2 adapter: support for creating new XI messages for received synchronous MDN messages. This was also stated in a small poll.
This feature was missing, but a lot of people wanted to have it. Now, in SP2, it is available and very easy to configure.
For that reason, I created a small blog to highlight the configuration and the result.
Overview
In a previous SP, the highlighted feature below was not available
Image may be NSFW.
Clik here to view.
Configuration
Within the receiver AS2 communication channel, make sure to indicate synchronous MDN messages and a reference to a sender AS2 communication channel, getting the incoming MDN message
Image may be NSFW.
Clik here to view.
Create a sender AS2 communication channel that corresponds to the one used in the receiver AS2 communication channel, configured in the previous step.
Image may be NSFW.
Clik here to view.
Result
Use http://testas2.mendelson-e-c.com:8080/webas2/ to look into message content on the Mendelson side.
For the SAP PO monitoring, this is the result(*)
Image may be NSFW.
Clik here to view.
(*) Please note that acknowledgements results are depending on the AS2 receiver capabilities. This example was built using Mendelson AS2
